IBM NetVista 6058 Hardware Maintenance Manual page 17

Diagnostic Error Code
001-027-XXXSystem Configuration/Setup error 1. Run Setup
001-032-XXXSystem Device Controller failure
001-034-XXXSystem Device Buffer Allocation
failure
001-035-XXXSystem Device Reset condition
detected
001-036-XXXSystem Register error
001-038-XXXSystem Extension failure
001-039-XXXSystem DMI data structure error
001-040-XXXSystem IRQ failure
001-041-XXXSystem DMA failure
001-195-XXXSystem Test aborted by user
001-196-XXXSystem test halt, error threshold
exceeded
001-197-XXXSystem test warning
001-198-XXXSystem test aborted
FRU/Action
2. Flash the system
3. System board
1. System board
1. Reboot the system
2. Flash the system
3. Run memory test
4. System board
1. System board
1. System board
1. Adapter card
2. System board
1. Flash the system
2. System board
1. Power-off/on system and re-test
2. System board
1. Power-off/on system and re-test
2. System board
1. Information
2. Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled
2. Re-run test
3. Component that is called out in warning statement
4. Component under test
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test
3. Go to the "Undetermined problems" section
Chapter 1. IBM PC Enhanced Diagnostics error codes
3