No-Beep Symptoms; Post Error Codes - IBM NetVista 6058 Hardware Maintenance Manual

No-beep symptoms

Note
Type 6568/6569/6648/6649 computers default to come up quiet (no beep
and no memory count and checkpoint code display) when no errors are
detected by POST.
To enable beep and memory count and checkpoint code display when a
successful POST occurs, do the following:
1. Select Start Options in the Configuration/Setup Utility program (see
2. Set Power-On Self Test to Enhanced.
Symptom/Error
No beep during POST but computer works
correctly.
No beep during POST.

POST error codes

In the following index, X can represent any number.
POST Error Code
000SCSI Adapter not enabled
02X
08XCheck SCSI terminator installation.
101System board interrupt failure
102System board timer error
72
Hardware Maintenance Manual: IBM NetVista Computer Types 6058, 6059, 6269, 6568, 6569, 6578, 6579, 6648,
6649
"Setup Utility program" on page 41).
FRU/Action
1. System Board
1. See "Undetermined problems" on page 90
2. System Board
3. Memory Module
4. Any Adapter or Device
5. Riser Card
6. Power Cord
7. Power Supply
FRU/Action
1. Verify adapter device and Bus Master fields
are enabled in PCI configuration program.
See documentation shipped with computer.
1. SCSI Adapter
1. SCSI Cable
2. SCSI Terminator
3. SCSI Device
4. SCSI Adapter
1. System Board
1. System Board