Table of Contents
Advertisement
10. Enter the default gateway on the traffic interface.
Complete the Join Setup
1. Provide the correct admin user password.
2. Specify the VPN Gateway type.
3. Wait until the Setup utility has finished.
User Guide
Provide the Management IP address of the cluster to which you want to join the
current VPN Gateway. To check the Management IP of an existing cluster, connect
to the cluster and use the /cfg/sys/cur command.
Enter default gateway IP address (on the traffic interface):<IP
addr>
The default gateway IP address should be within the same network address range
as the host IP address on the traffic interface.
Complete the join setup by following the instructions in the next section, "Complete
the Join Setup".
Type the correct password for the admin user.
( join setup, continued)
Enter the existing admin user password:
When adding up to three additional master AVGs to a cluster containing a single
VPN Gateway, you may configure each additional AVG as either master or slave.
For up to three additional AVGs, the default setting is master. When adding one or
more VPN Gateways to a cluster that already contains four master AVGs, each
additional AVG is automatically configured as slave.
It is recommended that there are 2-4 master AVGs in each cluster, so in most cases
there is no need to change the default setting. If needed, you can always reconfigure
a VPN Gateway by changing the Type setting after the initial setup. For more
information, see the type command in the "iSD Host Configuration" section under
Configuration Menu>System Configuration in the Avaya Command Reference.
Enter the type of this iSD (master/slave) [master]:
......ok
Joining a VPN Gateway to an Existing Cluster
April 2013
55
Advertisement
Table of Contents
