Table of Contents
Advertisement
3. Specify the host IP address for the current VPN Gateway.
4. Enter network mask and VLAN tag ID.
5. Enter yes and press ENTER to continue with creating a two-armed configuration.
6. Specify a new port number for the traffic interface.
7. Specify a host IP address on the traffic (public) interface.
8. Enter network mask and VLAN tag ID.
User Guide
Specify the port you want to use for AVG management and other private traffic
between the VPN Gateway and the intranet. This port will be assigned to the private
interface (Interface 1).
Enter IP address for this machine (on management interface):<IP
address>
Specify a host IP address on the management (private) interface. This IP address
must be unique on the network and be within the same network address range as
the Management IP address (see
host IP address is assigned to Interface 1.
Enter network mask [255.255.255.0]:<Press ENTER if correct>
Enter VLAN tag id (or zero for no VLAN) [0]:<VLAN tag id or ENTER>
Specify the desired network mask for the host IP address on the management
interface or accept the suggested value by pressing ENTER. If a connected router
or switch attaches VLAN tag IDs to incoming packets, specify the VLAN tag ID
used.
Setup a two armed configuration (yes/no) [no]:
Enter port number for the traffic interface [1-4]:
The traffic (public) interface port number will automatically be assigned to Interface
2.
Enter IP address for this machine (on traffic interface):<IP
address>
This IP address will be assigned to Interface 2 on the VPN Gateway, that is, the
public interface.
Installing an AVG in a New Cluster
step 10
on page 46). The management interface
yes
2
April 2013
45
Advertisement
Table of Contents
