Table of Contents
Advertisement
Performing the quick setup
24 Setting up the security gateway for configuration
Avaya SG203/SG208 Security Gateway Hardware Installation Guide
Restart your workstation, if the operating system asks you to do so. As
your workstation restarts, it automatically obtains its required IP address/
mask and default router IP address from the security gateway.
NOTE: Unless you have other DNS servers at your local site, it is
recommended that the Windows DNS and WINS server lists be empty.
The DNS server built into the security gateway should normally be the
sole DNS server that users see.
Quick Setup collects and preconfigures the essential information required
to remotely configure and manage the security gateway.
Note: If the security gateway is to be configured and managed locally,
see the Security Gateway Configuration Guide for the VPNos, to perform
a comprehensive device configuration.
The Quick Setup wizard collects the necessary information to
communicate with the remote VPNmanager application through the
security gateway's public port. The following information is required to
complete the quick setup:
•
The type of addressing to be used on the security gateway's public
port, either Static IP Addressing, Dynamic Addressing (DHCP), or
PPPoE. Typically, DSL connections use PPPoE and cable modems
use DHCP. The default is DHCP
•
A network mask for the above
•
A default route. This is the service provider's router used only if Static
IP Address is selected
•
The user name and password, if your connection to your ISP is PPPoE
To connect to the security gateway
From a workstation on the private side of the security gateway, open
1.
your browser and type into the location field one of the following:
•
https://sg.private
•
https://192.168.1.1 (security gateway default address)
Click Yes, to accept the security alert message. The security gateway
2.
login window appears.
Issue 1, June 2003
Advertisement
Table of Contents
