Avaya VPN Gateway User Manual page 67

2. Confirm the network port setting, and the IP network settings.
3. Select a download method, specify the server IP address, and the boot image file
User Guide
ForgetMe
Password:
*** Reinstall Upgrade Procedure ***
If you proceed beyond this point, the active network
configuration will be reset, requiring a reboot to restore any
current settings. However, no permanent changes will be done
until the boot image has been downloaded.
Continue (y/n)? [y]:<Press ENTER to continue>
(reinstall procedure, continued)
Select a network port (1-4, or i for info) [1]:<Press ENTER if
correct, or change to the port you are using for network
connectivity>
Enter VLAN tag id (or zero for no VLAN tag) [0]:<VLAN tag id or
ENTER>
Enter IP address for this iSD [192.168.128.185]: <Press ENTER if
the IP address displayed within square brackets is correct.>
Enter network mask [255.255.255.0]:<Press ENTER if correct.>
Enter gateway IP address [192.168.128.1]:<Press ENTER if
correct.>
Note:
If the VPN Gateway has not been configured for network access previously, or if
you have deleted the VPN Gateway from the cluster by using the /boot/
delete command, you must provide information about network settings such as
interface port, IP address, network mask, and gateway IP address. No suggested
values related to a previous configuration will be presented within square
brackets.
name.
(reinstall procedure, continued)
Select protocol (ftp/scp/sftp) [ftp]:
Enter FTP server address:
Enter file name of boot image:
Enter FTP Username [anonymous]:
password
Password:
Downloading boot image...
Installing new boot image...
Done
ftp
10.0.0.1
SSL-7.0.x-boot.img
john
Reinstalling the Software
April 2013 67