Setting Up A Two-Armed Configuration - Avaya VPN Gateway User Manual

Initial Setup
7. Enter a Management IP address (MIP).

Setting Up a Two-Armed Configuration

In a two-armed configuration, two separate interfaces are configured on the VPN Gateway,
one private interface for AVG management and intranet connections and one public interface
for Internet connections. Also see figure on
1. Choose new from the Setup menu.
2. Configure the management interface port number.
44 User Guide
Enter default gateway IP address (or blank to skip):<gateway IP
address>
Enter a default gateway IP address that is within the same network address range
as the host IP address configured in step 3.
Enter a unique Management IP address (MIP) that is within the same network
address range as the host IP address and the default gateway IP address.
Enter the Management IP (MIP) address:<IP address>
Making sure the MIP does not exist...ok
Trying to contact gateway...ok
Complete the
new
setup by following the instructions in the section
page 46.
[Setup Menu]
join - Join an existing iSD cluster
new - Initialize iSD as a new installation
boot - Boot menu
info - Information menu
exit - Exit
new
>> Setup#
Setup will guide you through the initial configuration of the
iSD.
Enter port number for the management interface [1-4]:
Comments? infodev@avaya.com
Complete the New Setup
Two-Armed Configuration
[global command, always available]
on
on page 40.
1
April 2013