D-Link xStack DGS-3420 Series Reference Manual page 408

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
SenderID TLV
Click the Apply button to accept the changes made for each individual section.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
NOTE: The MD Name value should not be more than 22 characters.
To add a maintenance association (MA), click the Add MA button.
Click the Add MA button to see the following window
The fields that can be configured are described below:
Parameter
MA
MA Index
VID
Click the Add button to add a new entry based on the information entered.
Click the <<Back button to discard the changes made and return to the previous page.
Click the Edit button to re-configure the specific entry.
None – Don't create MIPs. This is the default value.
Auto – MIPs can always be created on any ports in this MD, if that port is not configured
with an MEP of this MD. For the intermediate switch in an MA, the setting must be auto in
order for the MIPs to be created on this device.
Explicit – MIPs can be created on any ports in this MD, only if the next existent lower level
has an MEP configured on that port, and that port is not configured with an MEP of this
MD.
This is the control transmission of the SenderID TLV.
None – Don't transmit sender ID TLV. This is the default value.
Chassis – Transmit sender ID TLV with chassis ID information.
Manage – Transmit sender ID TLV with managed address information.
Chassis Manage – Transmit sender ID TLV with chassis ID information and manage
address information.
Figure 10-2 CFM MA Settings Window
Description
Enter the maintenance association name.
Enter the maintenance association index.
VLAN Identifier. Different MA must be associated with different VLANs.
397