Mld Proxy - D-Link xStack DGS-3420 Series Reference Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide

MLD Proxy

MLD Proxy Settings
This window is used to configure the MLD proxy state and MLD proxy upstream interface.
To view the following window, click L2 Features > L2 Multicast Control > MLD Proxy > MLD Proxy Settings, as
show below:
The fields that can be configured are described below:
Parameter
MLD Proxy State
VLAN Name
VID
Source IP Address
Unsolicited Report
Interval (0-25)
Unit
Static Router Port
Click the Apply button to accept the changes made for each individual section.
Click the Select All button to select all the ports for configuration.
Click the Clear All button to unselect all the ports for configuration.
Figure 4-66 MLD Proxy Settings window
Description
Use the radio buttons to enable or disable the MLD Proxy Global State.
Click the radio button and enter the VLAN name for the interface.
Click the radio button and enter the VLAN ID for the interface.
Enter the source IPv6 address of the upstream protocol packet. If it is not specified, zero
IP address will be used as the protocol source IP address.
The Unsolicited report interval. It is the time between repetitions of the host's initial report
of membership in a group. Default is 10 seconds. If set to 0, it means to send only one
report packet.
Select the unit you wish to configure.
Select the port that will be included in this configuration.
136