D-Link xStack DGS-3420 Series Reference Manual page 271

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter Description
Profile ID
Here the user can enter the Profile ID for the flow meter.
Profile Name Here the user can enter the Profile Name for the flow meter.
Access ID
Here the user can enter the Access ID for the flow meter.
Mode Rate – Specify the rate for single rate two color mode.
Rate – Specify the committed bandwidth in Kbps for the flow.
Burst Size – Specify the burst size for the single rate two color mode. The unit is in kilobyte.
Rate Exceeded – Specify the action for packets that exceed the committed rate in single rate
two color mode. The action can be specified as one of the following:
Drop Packet – Drop the packet immediately.
Remark DSCP – Mark the packet with a specified DSCP. The packet is set to drop for packets
with a high precedence.
trTCM – Specify the "two-rate three-color mode."
CIR – Specify the Committed information Rate. The unit is Kbps. CIR should always be equal or
less than PIR.
PIR – Specify the Peak information Rate. The unit is Kbps. PIR should always be equal to or
greater than CIR.
CBS – Specify the Committed Burst Size. The unit is in kilobyte.
PBS – Specify the Peak Burst Size. The unit is in kilobyte.
srTCM – Specify the "single-rate three-color mode".
Figure 7-46 ACL Flow meter Configuration window
260