D-Link xStack DGS-3420 Series Reference Manual page 160

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide
Parameter
IGMP Multicast VLAN
State
IGMP Multicast VLAN
Forward Unmatched
IGMP Multicast VLAN
Auto Assign VLAN
VLAN Name
VID (2-4094)
Remap Priority
Replace Priority
Click the Apply button to accept the changes made for each individual section.
Click the Add button to add a new entry based on the information entered.
Click the Edit button to configure the IGMP Snooping Multicast VLAN Settings for the specific entry.
Click the Delete button to remove the specific entry.
Click the Profile List link to configure the IGMP Snooping Multicast VLAN Settings for the specific entry.
After clicking the Edit button, the following page will appear:
Description
Click the radio buttons to enable or disable the IGMP Multicast VLAN state.
Click the radio buttons to enable or disable the IGMP Multicast VLAN Forwarding
state.
Specifies to enable or disable the assignment of IGMP control packets to the right
Multicast VLAN. If auto assign VLAN is enabled, the Switch will check for group
matching with multicast VLAN profiles of which the ingress port belongs to. If there is
a match, the result is "in profile" and the matching multicast VLAN will be set as a
packet VLAN. If this function is disabled, the Switch will do VID checking, and
afterwards, if the group does not match the current profile binding, the Switch will drop
this packet.
Enter the VLAN Name used.
Enter the VID used.
0-7 – The remap priority value (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN.
None – If None is specified, the packet's original priority is used. The default setting is
None.
Tick the check box to specify that the packet's priority will be changed by the Switch,
based on the remap priority. This flag will only take effect when the remap priority is
set.
Figure 4-84 IGMP Snooping Multicast VLAN Settings – Edit window
149