General war-
ABS warning
ning light e
light l/
brake failure
OFF
ON
OFF
Flashes at 1 Hz ABS not available
OFF
Flashes at 4 Hz Only RESIDUAL BRAKING FUNCTION
ON
OFF
ON
Flashes at 1 Hz At least one brake circuit without
ON
Flashes at 4 Hz At least one brake circuit in RESIDUAL
Alternate
Alternate flash-
flashing at
ing at 1 Hz
1 Hz
Alternate flas-
Alternate flas-
hing at 4 Hz
hing at 4 Hz
BMW Integral ABS - Fault table
Malfunctions
Only RESIDUAL BRAKING FUNCTION
available in both circuits (
Pull-away test not completed (
available in both circuits (
Self-diagnosis not completed (
Tail light/brake light inoperative
(
b
ABS (
BRAKING FUNCTION mode (
Fluid level in BMW Integral ABS too low.
Check the motorcycle as follows:
– Ignition OFF: is brake pressure OK at
– Are the brakes acting on both wheels?
– Is the brake system free from leaks, no
If the test outcome is negative it will be
necessary to diagnose the brake system
and address any faults as necessary.
Fluid level in the BMW Integral ABS is too
low, perform the checks listed above.
Only RESIDUAL BRAKING FUNCTION
available in at least one circuit (
Do not ride the motorcycle if you
have any doubts about the
dependability of the brake system.
Maintenance Instructions, Chapter 2)
66)
b
the brake levers?
signs of brake fluid escaping?
67)
b
68)
b
67)
b
68)
b
67)
b
67)
b
3
71