Lighting; Body Panels - BMW S 1000RR Rider's Manual

Lift the rear wheel and work
quick-release axle 2 through
the adjustment plate and into
the brake-caliper support and
the rear wheel.
Make sure that the quick-re-
lease axle fits into the recess
for the flats.
Insert left adjustment plate 1.
Install axle nut 2 with washer,
but do not tighten it at this
point.
Adjust chain sag ( 208).

Lighting

Replacing LED light
sources
WARNING
Vehicle overlooked in traffic
due to failure of the lights on
the vehicle
Safety risk
Always replace a faulty bulb at
the earliest possible opportun-
ity. Consult a specialist work-
shop, preferably an authorised
BMW Motorrad Retailer.
All light sources of the vehicle
are LED light sources. The
service life of the LED light
sources is longer than the
presumed vehicle service
life. If an LED light source
is faulty, please contact a
specialist workshop, preferably
an authorised BMW Motorrad
Retailer.

Body panels

Remove the side panel
NOTICE
The procedure described here
for the right side apply applies by
analogy to the left side panel.
Place the motorcycle on its
stand on firm, even ground.
Remove screws 1.
Remove screws 2.
10
197
z