Powering Down - Christie M Series Setup Manual

6. Adjust cross-hair pattern II, by adjusting the appropriate cap
focus with minimal flare.
7. Adjust cross-hair pattern III, by adjusting the appropriate cap screw. Adjust until the cross-hair image is in
focus with minimal flare.
8. Repeat step 5, 6, and 7 as required until all 3 cross-hair patterns are in equal sharp focus. If the boresight is
acceptable, see step 11. If the boresight does not appear to be converging to an acceptable level of image
quality, or if the lens will not focus over the correct range of throw distances, then the boresight requires
coarse adjustment, see step 9.
9. The original factory boresight can be approximately recovered, by positioning the 3 setscrews flush with
the front face of the lens mount plate, and in contact with the inner lens mount plate, see
Position Setscrew
10. If further action is required. Repeat 2.
11. Lock the setscrews, and re-check the boresight quality. Tighten the setscrew enough to ensure they will not
shift.

2.2.5 Powering Down

The projector can be powered down by using one of the following methods:
Remote Keypad/Built-In Keypad
• Press and hold P
-OR-
• Press P
OWER
-OR-
• Press P
OWER
For Step 2 and 3, if the second key is not pressed immediately, a confirmation window will appear.
NOTE:
The second key press must be pressed within 1 second of the window appearing.
After powering down, the Status LEDs cycle and the LCD displays the message "Cooling Down", until cool
down is complete.
Web User Interface (UI)
1. From the Main Tab, Select Power > OFF.
2. Select Yes.
M Series Setup Guide
020-100011-05 Rev. 1 (07-2012)
Flush. This may require adjusting both setscrews and cap screws.
F 2-3 P
IGURE
OWER
twice
once, then immediately press the DOWN key.
screw.
S F
OSITION ETSCREW LUSH
Section 2: Installation and Setup
Adjust until the cross-hair image is in
Figure 2-3
2-9