Christie M Series Setup Manual page 18

Section 2: Installation and Setup
Stacking Multiple Projectors
NOTE: The projectors can be stacked and hoisted in either an upright or inverted positions.
1. With one person positioned on each side of the stacking frame, lift the
top stacking frame onto the bottom stacking frame, aligning all four
stacking legs between the frames.
NOTE: Remove the locking pin from each stacking leg prior to
alignment and ensure the four stacking legs are fully seated on the
lower stacking frame.
2. Insert the locking pin through the holes in the stacking legs. Make sure each pin is fully inserted.
NOTE: The steel ball on the end of the pin keeps the pin from releasing inadvertently.
3. When required, repeat steps 1 and 2 for the third projector in the stack.
Stacking Alignment
Stacked projectors must be correctly aligned to one another so the resulting display is optimized. If hoisting the
stack, do so first and then align. To align the image, use pitch, yaw, or roll. Prior to aligning the image, turn the
locking nut to unlock then use the knob to adjust the image.
NOTE: Ensure to lock the locking nut to maintain the image adjustment.
2-6
Step 2 is a critical safety procedure that MUST
be observed. Failure to engage the locking pin
may cause the projectors to separate, resulting
in possible injury or death.
M Series Setup Guide
020-100011-05 Rev. 1 (07-2012)