Filters - Christie M Series Setup Manual

M series
Hide thumbs Also See for M Series:
Table of Contents

Advertisement

4 Maintenance
4.1

Filters

Dust Air Filter
Check projector air dust filters, at minimum, every month.
Dust air filters (if fitted), should be replaced whenever the lamp is replaced or between 200-500 hours,
depending on use. A clogged air filter reduces air flow and can lead to overheating and failure of the projector.
Check monthly by inspecting its color through the side vent grille with a flashlight. Replace grey colored
filters. Leave the filters in their sealed packaging until ready for use.
Replace Filters:
1. Unscrew the 2 captive screws at the top of each filter
door
(Figure 4-1 Replace
rest down and away from the projector.
2. Slide the air filter out and replace, vacuum or wash
the filter. Wash using mild soap and water.
Dry the filter before using.
3. Insert the new or cleaned air filter(s).
4. Secure the filter door by tightening the 2 captive
screws loosened in Step 1.
Fog Filter
Fog filters should be replaced after each use of the projector to a maximum of 20 hours. The life of the filter is
approximately 20 hours based on environmental conditions. Leave the filters in their sealed packaging until
ready for use.
NOTE:
overheat and shutdown.
Replace Filters:
1. Unscrew the 2 captive screws at the top of each filter door
rest down, away from the projector.
2. Slide the filter (or dust air filter, if fitted) out.
3. Insert the new air fog filter with ensuring the white layer facing into the projector.
two-stage filter; the black activated charcoal layer faces out, and the white layer faces the projector.
4. Secure the filter door by tightening the 2 captive screws loosened in Step 1.
M Series Setup Guide
020-100011-05 Rev. 1 (07-2012)
Use only special, high efficiency Christie approved filters.
This projector is not equipped with fan finger guards. Keep fingers away from
the fan blades when replacing filter.
Filter). Allow the door to
The fog filters cannot be re-used or they will clog up with oil and the projector will
NOTE:
F
(Figure 4-1 Replace
4-1 R
F
IGURE
EPLACE
ILTER
Filter). Allow the door to
Each filter is a
NOTE:
4-1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents