Traps - Christie M Series Setup Manual

Section 3: Operation

3.4.3 Traps

A trap is a condition that SNMP monitors on the
projector. When the condition is met, a notification is
sent via an SNMP notification or email message. Each
traps condition can be set to Disabled, SNMP Trap,
Email or SNMP Trap + Email. The traps are defined in
a series of MIB files hosted directly on the projector.
MIB files can be accessed from a windows explorer
window, using the address //<hostname>/MIBs.
The Trap Configuration menu can be accessed from:
Configuration > Communications > SNMP > Trap
Configuration
Operators are able to select from the following trap events to receive up to 3 SNMP traps and 3 email
notifications when they occur:
Table 3.3 Available Trap Events
EVENT
Lamp end of life
Lamp end of life cleared
Lamp fault
Lamp fault cleared
Fan stall
Fan no longer stalled
Thermal sensor warning
Thermal sensor error
Thermal sensor OK
Projector powered on
(Standby to Lamps On)
Projector powered off
(Lamps On to Standby)
No video input signal
Video input signal detected Video input signal detected
Lamp door open
Lamp door closed
3-14
MESSAGE
(EMAIL NOTIFICATION)
Lamp has reached end of life
Lamp end of life cleared
Lamp fault has occurred
Lamp fault has been cleared
Fan stalled
Fan stall cleared
Thermal sensor warning
Thermal sensor error
Thermal sensor OK
Projector turned on (lamps on)
Projector turned off (lamps
off)
No video input signal
Lamp door has been opened
Lamp door has been closed
TRAP CONFIG.
PARAMETERS
Lamp Number
Lamp Hours Elapsed
Lamp Life
Lamp Number
Lamp Number
Lamp Fault Descrip-
Lamp Fault
tion
Lamp Number
Fan Name Fan Stall
Thermal Sensor Name
Thermal Sensors
Thermal Sensor Text
None Power
Frequency Signal Lost/Detected
Lamp Number Lamp Door
DEFAULT
NOTIFICATION
MENU TEXT
SETTING
SNMP Trap +
Email
Disabled
M Series Setup Guide
020-100011-05 Rev. 1 (07-2012)