Removing The Access Panel; Figure 3-2: Removing The Access Panel - HP Proliant ML310 Setup And Installation Manual

Hardware Options Installation

Removing the Access Panel

To remove the access panel:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal server components to cool before touching them.
CAUTION: To prevent damage to equipment or loss of information, be sure that the
server is powered down, all cables are disconnected from the back of the server, and
the power cord is disconnected from the grounded (earthed) AC outlet before
removing the access panel.
CAUTION: Do not operate the server while the access panel is removed. This panel
is an integral part of the cooling system and removing the panel while the server is
running may adversely affect data integrity.
1. Follow the steps in "Removing the Front Bezel" in this chapter.
2. Remove the thumbscrew located on the left side of the front chassis (1).
3. Slide the access panel forward, pull from the top of the access panel, and then lift
the panel from the chassis (2).

Figure 3-2: Removing the access panel

3-4
2
HP ProLiant ML310 Server Setup and Installation Guide
1