Figure 3-7: Removing A Hard Drive - HP Proliant ML310 Setup And Installation Manual

Hardware Options Installation
4. Remove the two screws on each side of the drive (1), and then gently pull the
drive out of the drive bay (2).
1

Figure 3-7: Removing a hard drive

5. Slide the drive compartment back into the chassis, and then replace the three hard
drive compartment shipping screws.
6. Connect the power and data cables to the back of all devices.
7. Replace the access panel and the front bezel.
8. Restore power to the server.
3-10
1
2
HP ProLiant ML310 Server Setup and Installation Guide