Scsi Cabling - HP Proliant ML310 Setup And Installation Manual

Cabling Guidelines

SCSI Cabling

IMPORTANT: The cabling procedures in this section apply only to SCSI models of the
ProLiant ML310 server or ATA models with a SCSI option board. Refer to the section, "ATA
Cabling," in this chapter for information on cabling ATA models.
ATA models with a SCSI option board require a SCSI cable not included with the SCSI board
option kit. Refer to the HP ProLiant ML310 Server Cabling Matrix for cable information specific
to your model.
Consider the following guidelines when adding SCSI devices to the server:
·
As a general rule, a maximum of seven devices may be added per channel. The
server is equipped with one integrated Wide Ultra3 SCSI channel.
·
Be sure to remove all terminating jumpers from third-party SCSI devices.
·
You must manually set the SCSI ID on each device to a unique value in the range
of 0 through 6 for each SCSI bus. Refer to the documentation provided with the
device for instructions on how to set the SCSI ID.
4-2 HP ProLiant ML310 Server Setup and Installation Guide