Figure 2-2: Powering Up The Server - HP Proliant ML310 Setup And Installation Manual

Overview of Server Installation
3. After the cables have been connected, you are ready to power up the server by
pressing the power button on the front of the server.

Figure 2-2: Powering up the server

4. Follow the onscreen instructions to complete the factory-installed operating
system initialization process. After initialization is complete, the server
automatically goes through Power-On Self-Test (POST).
IMPORTANT: To avoid automatic RAID 0 configuration in ATA models, you must configure
an array before OS installation. If you change the RAID level, you must re-install the operating
system. Refer to Chapter 6 for more information on configuring arrays.
5. To manage the server, install Insight Manager, found on the Management CD.
For Management CD initialization procedures, refer to the ProLiant Essentials
Foundation Pack shipped with the server.
IMPORTANT: You must install and use Insight Manager to benefit from the Pre-Failure
Warranty on processors, hard drives, and memory modules.
2-8 HP ProLiant ML310 Server Setup and Installation Guide