Jumper Settings; Scsi Device Jumper Settings; Ata Device Jumper Settings - HP Proliant ML310 Setup And Installation Manual
Hide thumbs
Also See for Proliant ML310:
- User manual (124 pages) ,
- Maintenance and service manual (90 pages) ,
- Quickspecs (39 pages)
Table of Contents
Advertisement
Jumper Settings
SCSI Device Jumper Settings
No two SCSI devices connected to the same SCSI controller can have the same
SCSI ID. If another SCSI device is connected to the controller, check its SCSI ID
before beginning the installation procedure for the additional device. The SCSI ID is
set by jumpers located on each device. For more information, refer to the SCSI
device option documentation.
ATA Device Jumper Settings
When installing any ATA devices, be sure that the jumper on the device is set to
Cable Select (CS). This setting allows the cable to automatically assign the device ID
of an ATA drive attached to the cable. For information on cabling ATA devices, refer
to Chapter 4, "Cabling Guidelines."
HP ProLiant ML310 Server Setup and Installation Guide
LED Indicators, Switches, and Jumpers
E-13
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
