Table E-4: System Configuration Switch Settings - HP Proliant ML310 Setup And Installation Manual

Table E-4: System Configuration Switch Settings

Position
1
2
3
4
5
6
7
8
Note: Switch positions 1, 7, and 8 are reserved for authorized service
providers only. Do not change the specified default setting for these
positions, unless instructed otherwise.
HP ProLiant ML310 Server Setup and Installation Guide
CAUTION: Clearing nonvolatile RAM (NVRAM) deletes the
system configuration. Refer to Chapter 5, "Server Configuration
and Utilities," for instructions on configuring the server.
Default Description
Off Reserved
Off Lock configuration
Off Tower/rack
configuration
Off Diskette boot
Off Password override
Off Clear CMOS and
NVRAM
Off Reserved
Off Reserved
LED Indicators, Switches, and Jumpers
Settings
N/A
Off = Normal operation
On = Configuration
changes cannot be
made
Off = Tower
configuration
On = Rack configuration
Off = Observe RBSU
diskette boot selection
On = Override RBSU
diskette boot selection
and allow boot to
diskette
Off = Normal
On = Override password
prompts
Off = Normal
On = When the server is
powered up, all system
configuration
information is erased
N/A
N/A
E-9