Troubleshooting; Drive Connection Tips - HP Proliant ML310 Setup And Installation Manual

Novell Operating Systems
·
From the console, type
that the module has been unloaded.
·
To start the utility again, simply type
respond with a message verifying this operation.
Linux Operating Systems
·
From a prompt, type
·
To restart the utility, type

Troubleshooting

·
Inconsistent naming may occur between the Power-On Self Test (POST) and the
Integrated ATA RAID Configuration Utility. Such is the case when a drive has
failed in a RAID 1 or RAID 1+0 configuration. The POST message will list the
array as running in a
Configuration Utility will list it as being in a
inconsistency occurs, the array must be rebuilt.
·
If you add drives to a configuration, the Integrated ATA RAID Management
Utility tray icon (which is seen only under Microsoft operating systems) may
indicate yellow or red, depending on the array condition. The color change
indicates one of the following situations:
— Errors are present on the array.
— Error data from an earlier application of the drive is present, and is
mistakenly being presented as new errors. Right-click on the tray icon and
select Erase Error Log from the menu. If these are new errors, they will be
rediscovered by the server.

Drive Connection Tips

·
If you have two drives, connect one on each ATA/100 RAID channel. The
performance of the array is enhanced when both channels are utilized.
HP ProLiant ML310 Server Setup and Installation Guide
. The system should respond with a message
Unload Spy
Load Spy
.
Spy-Stop
.
Spy-Start
state and the Integrated ATA RAID
Degraded
RAID Configuration and Management
. Once again, the system should
state. If this
Rebuilding
6-9