Table of Contents
Advertisement
13 MAINTENANCE
13.1 GENERAL
The inherent quality of the solid-state components in STANDARD HORIZON
radios will provide many years of continuous use. Take the following precau-
tions to prevent damage to the radio.
To prevent corrosion of electrical contacts and keep the water resistance,
keep the microphone connected or the jack covered at all times.
Never key the transmitter unless an antenna or suitable dummy load is
connected to the antenna receptacle.
Use only STANDARD HORIZON-approved accessories and replacement
parts.
In the unlikely event of serious problems, please contact your Dealer or our
repair facility. Address and phone numbers for this facility, as well as warranty
information, are contained in section "15 WARRANTY."
13.2 REPLACEMENT PARTS
Occasionally an owner needs a replacement part. These can be ordered from
our Parts Department by writing or calling:
Marine Division of YAESU U.S.A.
6125 Phyllis Drive, Cypress, California 90630, U.S.A.
Telephone (800) 767-2450
Commonly requested parts, and their part numbers are listed below.
CD-38 Charger Cradle: CB4505002
CAT460 Antenna: AY139X001
Belt Clip (CLIP-19): CP9173001
DISTRESS Cover Cap: RA0995600
MIC/SP Plastic Cap: RA1087000
MIC/SP Cap O-Ring: RA046760A
MIC/SP Rubber: RA1030500
HX851
Page 87
Advertisement
Table of Contents
