Table of Contents
Advertisement
7. When you have completed your selection, press the
several times to return to radio operation.
6.10.3 MEMORY SCANNING ( M-SCAN )
1. Press the
/
key until the background noise disappears.
2. Press the
display. Scanning will proceed from the lowest to the
highest Preset Channel and channels programmed into
memory.
3. When an incoming signal is detected on one of the channels during scan,
the radio will pause on that channel, allowing you to listen to the incoming
transmission. The channel number will blink during reception.
4. When the transmission stops the radio will automatically start memory scan
again.
5. To stop scanning, press the
By default the HX851 will alarm when on a weather channel, and on the
last selected Weather channel during scanning. For additional settings,
refer to section "8.10 WEATHER ALERT".
6.10.4 PRIORITY SCANNING ( P-SCAN )
The "Priority Scan" allows the radio to "Memory Scan" while also keeping watch
on a particularly important "Priority Channel". In the default setting, Channel
16 is set as the priority channel. You may change the priority channel to the
desired channel from Channel 16 in the "Radio Setup" menu, refer to section
"8.5 PRIORITY CHANNEL".
1. Press the
/
key until the background noise disappears.
2. Press the
display. Scanning will proceed between the Preset
Channel, channels programmed into memory and the
priority channel. The priority channel will be scanned
after each programmed channel.
3. To stop scanning, press the
Page 32
key to activate the squelch adjusting mode, then press the
key, the "
16/9
key to activate the squelch adjusting mode, then press the
key, the "
16/9
" icon appears on the
or
key.
NOTE
" icon appears on the
or
key.
key or press the
16/9
HX851
Advertisement
Table of Contents
