Standard Horizon HX851 Owner's Manual page 36

7.2.2 USER MMSI PROGRAMMING
A user MMSI can be inputted only once (as per governmental regula-
tion). Therefore please be careful not to input the incorrect MMSI num-
ber. If you need to change the MMSI after it has been programmed, the
radio will have to be returned to Factory Service. Refer to the section
"13.3 FACTORY SERVICE".
VHF handhelds used in the United States should use the MMSI as-
signed to the ship to which the handheld is primarily associated, even if
another radio on that ship uses the same MMSI. If you plan to use the
handheld on other boats, you might want a separate MMSI number so
that you can update the registration according to which boat it is cur-
rently on.
1. Press and hold down the
Menu" appears.
Menu Menu
Menu Menu
2. Press the
3. Press the
select "User MMSI User MMSI", and press the
User MMSI User MMSI
User MMSI
4. Press the
ber of your MMSI, then press the
to the next number.
5. Repeat step 4 to set your MMSI (nine digits).
6. If a mistake was made entering, repeatedly press
the key until the wrong number is selected,
then press the
7. When finished programming the number, press and
hold the
8. Enter your MMSI number again using steps 4, 5, and
6.
9. To save the MMSI into the radio, press and hold the
key.
10. Press the
Page 36
WARNING
IMPORTANT NOTE
key until the "Setup
key to select "DSC Setup DSC Setup" menu.
DSC Setup DSC Setup DSC Setup
key, then press the
/ key to select the first num-
/ key to correct entry.
key.
key twice to return to radio operation.
Setup Setup
Setup Setup
key to
key.
key to step
HX851