Standard Horizon HX851 Owner's Manual page 55

7.8.2 SETTING UP THE POSITION REQUEST RINGER
The HX851 has the capability to turn off the Position Request ringer.
1. Press and hold the
appears.
2. Press the
3. Press the
the /
4. Press the
5. Press the
quest", then press the
quest quest
quest quest
6. Press the
7. Press the
Menu", then press the
Menu Menu
Menu Menu
radio operation.
To enable the ringer tone, repeat the above procedure,
press the key to select "On
7.8.3 TRANSMITTING A POSITION REQUEST TO ANOTHER VESSEL
Pre-Programmable Request
1. Press the
pear in the display.
2. Press the
quest quest
quest quest". quest
3. Press key. The names shown have been previ-
ously saved in the Individual directory.
4. Press the
press the
5. Press the
Request DSC call.
6. When the HX851 receives the position from the
polled vessel, a ringing alarm will sound, and
the display shows the position of the vessel and
also transferred to a GPS Chart plotter if con-
nected.
7. Press any key to stop the alarm.
8. If you wish to display the position of the polled vessel
on the "WAYPOINT" screen, go to next step, other-
wise press the
9. Press the
10. Press and hold the
HX851
key until "Setup Menu
key to select "DSC Setup DSC Setup" menu.
DSC Setup DSC Setup DSC Setup
key, then select "DSC Beep
key.
key.
/ key to select "Position Re-
key.
key to select "Off
Off Off Off". Off
key twice to return to the "Setup
key again to return to
On" in step "6" above.
On On
On
key. The "DSC Call Menu DSC Call Menu" will ap-
DSC Call Menu DSC Call Menu
DSC Call Menu
/ key to select the "Pos Re-
/ key to select a name, then
key.
key again to transmit the Position
key to return to radio operation.
key to enter the "Waypoint Input
key several times until the display changes to the
Setup Menu Setup Menu
Setup Menu" Setup Menu
DSC Beep" with
DSC Beep DSC Beep
DSC Beep
Position Re- Position Re-
Position Re- Position Re-
Setup Setup
Setup Setup
Pos Re- Pos Re- Pos Re- Pos Re-
Waypoint Input" menu.
Waypoint Input Waypoint Input
Waypoint Input
Page 55