CyberData 010935B Operation Manual page 34

2.1.4.1 Point-to-Point Configuration
When the board is set to not register with a SIP server (see
intercom to dial out to a single endpoint.
In this case, the dial-out extension should be the IP address of the remote device. The Intercom can
also receive Point-to-Point calls. The delayed DTMF functionality is available in the Point-to-Point
Mode.
Note
Operations Guide
Receiving point-to-point SiP calls may not work with all phones.
Figure 2-21. SIP Setup Page Set to Point-to-Point Mode
930242F
Configure the Intercom Parameters
Figure 2-21), it's possible to set the
Board is set to not register with a SiP server
Installing the VoIP Intercom
CyberData Corporation
28