CyberData 010935B Operation Manual page 33

Web Page Item
Authenticate ID*
Authenticate Password*
SIP Registration*
Register Expiration*
Dial-Out Extension
3. After changing the parameters, click Save Settings.
Operations Guide
Table 2-7. SIP Setup Parameters (continued)
Description
Enter the Authenticate ID (up to 25 alphanumeric
characters).
Enter the Authenticate Password (up to 25 alphanumeric
characters).
Enable/Disable SIP Registration.
For information about the Point-to-Point Configuration, see
Section 2.1.4.1, "Point-to-Point
Enter the SIP Registration lease time in minutes (default 60
minutes).
Enter the button dial-out extension number.
The Dial Out Extension also supports the addition of
comma delimited pauses before sending additional DTMF
tones (using rfc2833). The first comma will pause three
seconds after a call is first established with a remote
device. Subsequent commas will pause for two seconds. A
pause of one second will be sent after each numerical digit.
Examples of Dial-Out Extension strings:
302: Dial out extension 302 and establish a call.
302,2: Dial out extension 302 and establish a call. Wait
three seconds and then send the DTMF tone '2'.
302,25,,,4,,1: Dial out extension 302 and establish a call.
Wait 3 seconds and then send the DTMF tone '2'. Send out
DTMF tone 5. Wait six seconds. Send out DTMF tone 4.
Wait four seconds. Send out DTMF tone 1.
Note: The maximum number of total characters in the dial-
out field is 25.
Click this button to save your configuration settings.
Changing a parameter that has an asterisk next to it will
cause a system reboot when saved.
Link to the Intercom Setup page.
Link to the Network Setup page.
Link to the Upgrade Firmware page.
Link to the Home page.
930242F
Installing the VoIP Intercom
Configure the Intercom Parameters
Configuration".
CyberData Corporation
27