Initialize Procedure; Memory Clear Procedure - Minolta CF2002 Service Manual

(1)

Initialize Procedure

1. Turn OFF the Power Switch.
2. With the circuit across pins of PJ2 closed, turn ON the Power Switch.
3. In about 5 sec., open the PJ2 circuit.
4. Check that the message "Initialize Completed" is displayed on the Touch Panel and
then touch "END."
(2)

Memory Clear Procedure

1. Turn OFF the Power Switch.
2. With the circuit across TP1 and TP3 closed, turn ON the Power Switch.
3. In about 5 sec., open the circuit across TP1 and TP3.
4. Check that the message "Memory Clear Completed" is displayed on the Touch Panel
and then touch "END."
5. The following types of data are cleared.
• Utility mode: Input, User's Choice 1/2
• Tech. Rep. mode: System Input, Administrator # Input
• Security mode: Counter Setting
• Touch Panel Adj.
NOTES
• If the copier exhibits an erratic display or operation, unplug and plug in the power cord,
turn OFF and ON the Power Switch, and then perform the following procedures in this
order: Initialize → Memory Clear.
• Do not perform Memory Clear casually, as it clears the types of data mentioned above. If
Memory Clear has been performed, be sure to make settings for the functions that have
been cleared once again.
S-2