Remounting Ram Ic (Ic202 - Minolta CF2002 Service Manual

4-4.

REMOUNTING RAM IC (IC202)

1. Remove the Image Control Board (PWB-F) from the copier.
2. Remove RAM IC (IC202) from the old Image Control Board (PWB-F).
3. Remove RAM IC (IC202) from the NEW Image Control Board (PWB-F) and then install
the RAM IC (IC202) from the old Image Control Board (PWB-F) on the NEW Image
Control Board (PWB-F).
NOTE
• If the Image Control Board (PWB-F) has been replaced and RAM IC (IC202) is not to be
remounted, be sure to record all data of Utility mode and Tech. Rep. mode functions and
make the entries again of these numeric values.
NOTE
• Note the alignment notch (A) on RAM IC
when mounting it.
4025D137AA
D-74
4025D137AA