Reinstallation Procedure - Minolta magicolor 7300 Service Manual

FrameMaker Ver.6E (PC) magicolor 7300 ASSEMBLY/DISASSEMBLY
02.08.08
<Reinstallation Procedure>
4134D132AA
4134D131AA
4134D134AA
4134D141AB
Pulley end
1. Position the round bead of the wire stopper in the
pulley as shown.
NOTE
• Make sure that the bead snugly rests in the slit in
the pulley.
Hook end
2. Position the round bead of the wire stopper in the
hook as shown.
NOTE
• Make sure that the bead snugly rests in the slit in
Wire Holder A.
• Make sure that the bead snugly rests in the slit in
the hook.
3. Wind the pulley end of the cable around the pul-
ley five turns counter clockwise, from the rear
toward the front.
NOTE
• Make sure that no part of the cable rides on the
other.
4. Install Holder A using three screws.
D-46