Specifications - Strong Srt Ant 10 Eco User Manual

No response to remote
control
Forgotten PIN code
After moving the receiver
to another room / area
you are no longer able to
receive digital reception
The receiver switches off
automatically.

8.0 SPECIfICATIonS

Demodulator:
Demodulator:
Transmission mode:
video Decoder:
Profile level:
Video resolution:
Decoding & Video Out:
Aspect ratio:
Audio Decoder:
MPEG MusiCam Layer 2
Sampling rate:
Audio mode:
Tuner:
Front End:
Input frequency range:
Loop through frequency range:
Input signal level:
multimedia:
Video playback:
Audio playback:
Picture view:
14
Receiver off
Remote not aimed correctly
Front panel obstructed
Remote batteries exhausted
Antenna signals are too weak
Auto Standby function
enabled.
COFDM; 16 QAM/64 QAM
2 K - 8 K
MPEG2 MP@ML
720 x 576 pixels (PAL), 720 x 480 (NTSC)
PAL & NTSC
4:3, 16:9
32, 44.1, 48 kHz
Stereo, Joint Stereo, Dual Mono, Mono
DVB-T, UHF & VHF Tuner
174 ~ 230 MHz (VHF) and 470 ~ 862 MHz (UHF)
47 ~ 862 MHz
-82 ~ -20 dBm
MPEG-1 and MPEG-2 encoded (mpg)
MP3 and WMA formats
JPEG format
Plug in and turn on plug
Aim remote at front panel
Check for obstructions
Replace remote batteries
Contact local Service Hotline or
send email to our Support via www.
strong.tv
Press the Info button on remote
3x to call up signal bars and adjust
antenna for (maximum) reception
or rescan channels
Disable auto standby. See section
5.3.8 for details.
PART 1 • English