Usage Of External Usb Devices; Connection; Connecting To Tv And Terrestrial Antenna; Connecting To A Digital Audio Amplifier - Strong Srt Ant 10 Eco User Manual

PART 1 • English

1.5 Usage of external USb devices

It is recommended to use USB 1.1 storage devices. If your device is not compatible to
„ „
USB 1.1 specifications, playback and other multimedia functions of the receiver would
not work properly.
To ensure best performance of your USB storage device please format it by this
„ „
receiver (menu Media+ > Disk Format) to FAT32 system. Other file systems are not
supported by the receiver.
STRONG cannot guarantee compatibility to all types of USB storage devices.
„ „
If you are going to use external USB HDD (Hard Disk Drive) please consider that the
„ „
power specifications might exceed the supported output of your receiver (5 V/800
mA). If so, please connect your USB HDD to an according external power adapter.
It is advised not to store important information on USB storage devices used with
„ „
the receiver. Always make backups of data on USB storage device before usage
with receiver. STRONG will not take responsibility for any loss of information or
circumstances caused by loss of information.

2.0 ConnECTIon

2.1 Connecting to Tv and Terrestrial Antenna

To receive the broadcast signal, the terrestrial antenna cable should be connected to the ANT IN
connector at the back of the receiver. (Fig. 1)

2.2 Connecting to a Digital Audio Amplifier

Connect your Digital Audio Amplifier with the S/PDIF connector on the back of the receiver (Fig. 1).

3.0 YoUR RECEIvER

3.1 front Panel

1. USb

3.2 Rear Panel

1. AnT In
2. To Tv
3. S/PDIf Coaxial
4. Tv SCART Connector
5. Power Cord
Connects to USB device
To connect an antenna for reception of broadcasting signal.
Active antennas can be supported with max. 5 V/500 mA DC.
To connect a TV set or to connect an extra receiver.
To connect your receiver to digital audio amplifier.
To connect your receiver with your TV set using a SCART cable.
Your receiver requires a voltage of 220 – 240 V AC (Auto-
selectable), 50/60 Hz +/-5 %. Make sure to check the power
specification before connecting your receiver to the wall outlet.
Fig. 2
Fig. 3
5