Floppy Configuration; Boot Settings Configuration - Supero SUPER P3TDLR User Manual

Hide thumbs Also See for SUPER P3TDLR:
Table of Contents

Advertisement

S
UPER P3TDLR User's Manual

Floppy Configuration

Floppy A
Use this option to specify which of floppy drive you have installed in the A
drive. The settings are Disabled, 360 KB 5 1/4", 1.2 MB 5 1/4", 720 KB 3 1/
2", 1.44 MB 3 1/2" and 2.88 MB 3 1/2".
Floppy B
Use this option to specify which of floppy drive you have installed in the B
drive. The settings are Disabled, 360 KB 5 1/4", 1.2 MB 5 1/4", 720 KB 3
1/2", 1.44 MB 3 1/2" and 2.88 MB 3 1/2".
Diskette Write Protect
This option allows you to prevent any writing to your floppy diskette. The
settings are Enabled and Disabled. The Enabled setting is effective only if
the device is accessed through BIOS.
Floppy Drive Seek
Use this option to Enable or Disable the floppy seek routine on bootup.

Boot Settings Configuration

Quick Boot
This option allows the BIOS to skip certain tests that are normally performed
on boot up. You can disable the option to speed up boot time. The settings
are Disabled and Enabled.
Quiet Boot
If Disabled, this option will cause the normal POST messages to be dis-
played upon setup. When Enabled, the OEM logo is displayed instead of the
POST messages. The default setting is Disabled.
Add-On ROM Display Mode
Set this option to display add-on ROM (read-only memory) messages. The
settings for this option are Force BIOS and Keep Current.
allows the computer to force a third party BIOS to display during system
boot. Keep Current has the system display AMIBIOS information on bootup.
4-10
Force BIOS

Advertisement

Table of Contents
loading

Table of Contents