I/O Ports; Installing Processors - Supero SUPER P3TDLR User Manual

Hide thumbs Also See for SUPER P3TDLR:
Table of Contents

Advertisement

2-4

I/O Ports

The I/O ports are color coded in conformance with the PC 99 specification.
See Figure 2-2 below for the colors and locations of the various I/O ports.
Mouse
(Green)
Keyboard
USB
(Purple)
Ports
(Black)
Note: The COM2 Port is a header on the motherboard, located next to the
mounting hole between the Super I/O chip and the RAGE XL chip.
2-5

Installing Processors

!
1.
Installing the FCPGA processors:
The P3TDLR has two 370-pin sockets, which support single or dual Intel
®
Pentium
III FCPGA 500 MHz-1.26+ GHz processors and single or dual
low power Pentium
MHz. Lift the lever on the FCPGA socket and insert the processor (with
the heat sink attached) keeping the notched corner oriented toward pin
one on the socket. Make sure the processor is fully seated in the socket
and then close the lever. You can also install a single processor on the
motherboard without changing any jumper settings. (See Figure 5-4 for
views of a 370-pin FCPGA socket before and after processor installa-
tion.)
COM1 Port
(Turquoise)
Figure 2-2.
Avoid placing direct pressure to the top of the pro
cessor package.
and always remove it before adding, removing or
changing any hardware components.
®
III processors at front bus speeds of 133 and 100
VGA Graphics
Port (Blue)
I/O Ports
Always connect the power cord last
2-5
Chapter 2: Installation
LAN1
LAN2

Advertisement

Table of Contents
loading

Table of Contents