Table of Contents
Advertisement
S
UPER P3TDLR User's Manual
NOTE
If you are a system integrator, VAR or OEM, a POST
diagnostics card is recommended. For I/O port 80h codes,
refer to App. B.
Memory Errors
1. Make sure the DIMM modules are properly and fully installed.
2. Determine if different speeds of DIMMs have been installed and verify
that the BIOS setup is configured for the fastest speed of RAM used.
It is recommended to use the same RAM speed for all DIMMs in the
system.
3. Make sure you are using PC133 or PC100 compliant, registered ECC
SDRAM. EDO and unbuffered SDRAM are not supported.
4. Check for bad DIMM modules or slots by swapping a single module
between two slots and noting the results.
5. Make sure all memory modules are fully seated in their slots.
6. Check the power supply voltage 115V/230V switch.
Losing the System's Setup Configuration
1. Check the setting of jumper JBT1. Ensure that you are using a high
quality power supply.
system to lose the CMOS setup information. Refer to page 1-13 for
details on recommended power supplies.
2. The battery on your motherboard may be old. Check to verify that it
still supplies ~3VDC. If it does not, replace it with a new one.
3. If the above steps do not fix the Setup Configuration problem, contact
your vendor for repairs.
3-2
Technical Support Procedures
Before contacting Technical Support, please take the following steps. Also,
note that as a motherboard manufacturer, Super Micro does not sell directly
to end-users, so it is best to first check with your distributor or reseller for
troubleshooting services.
with the specific system configuration that was sold to you.
1. Please go through the 'Troubleshooting Procedures' and 'Frequently
Asked Question' (FAQ) sections in this chapter or see the FAQs on our
A poor quality power supply may cause the
They should know of any possible problem(s)
3-2
Advertisement
Table of Contents
