Table of Contents
Advertisement
asset tracking can occur after hours and on weekends so that daily LAN
traffic is kept to a minimum and users are not interrupted. The motherboards
have a 3-pin header (WOL) to connect to the 3-pin header on a Network
Interface Card (NIC) that has WOL capability. Wake-On-LAN must be en-
abled in BIOS. Note that Wake-On-Lan can only be used with an ATX 2.01
(or above) compliant power supply.
1-6
Power Supply
As with all computer products, a stable power source is necessary for
proper and reliable operation. It is even more important for processors that
have high CPU clock rates.
The SUPER P3TDLR accommodates ATX power supplies.
power supplies generally meet the specifications required by the CPU, some
are inadequate.
power - or even higher wattage power supply is recommended for high-
load configurations.
voltage that supplies at least 1.5A of current.
It is strongly recommended that you use a high quality power supply that
meets ATX power supply Specification 2.02 or above.
eas where noisy power transmission is present, you may choose to install
a line filter to shield the computer from noise. It is recommended that you
also install a power surge protector to help avoid problems caused by
power surges.
1-7
Super I/O
The disk drive adapter functions of the Super I/O chip include a floppy disk
drive controller that is compatible with industry standard 82077/765, a data
separator, write pre-compensation circuitry, decode logic, data rate selec-
tion, a clock generator, drive interface control logic and interrupt and DMA
logic.
The wide range of functions integrated onto the Super I/O greatly
reduces the number of components required for interfacing with floppy disk
drives. The Super I/O supports 360 K, 720 K, 1.2 M, 1.44 M or 2.88 M disk
drives and data transfer rates of 250 Kb/s, 500 Kb/s or 1 Mb/s.
provides two high-speed, 16550 compatible serial communication ports
(UARTs), one of which supports serial infrared communication. Each UART
includes a 16-byte send/receive FIFO, a programmable baud rate generator,
complete modem control capability and a processor interrupt system.
Each UART includes a 16-byte send/receive FIFO, a programmable baud
You should use one that will supply at least 300W of
Also your power supply must provide a +5V standby
1-13
Chapter 1: Introduction
Although most
Additionally, in ar-
It also
Advertisement
Table of Contents
