Setting Rf Traps - Motorola WS2000 System Reference Manual

3. Click the Apply
4. It is necessary to tell the switch where to send the notifications. Make sure to set the trap configuration
to indicate where to send the trap notifications.

7.11.7 Setting RF Traps

A screen is also available to specify traps caused when certain rates of activities either exceed or drop below
a specified threshold. To set rate traps, select
Traps from the left menu.
1. Select the threshold type for which you want a rate trap, such as Pkts/sec.
2. Determine whether you want the rate to apply to
enabled), Ap
3. Type in the threshold rate into the field associated with the selected object.
4. Traps are only generated for those field where numbers exist. Explanation of the different threshold types
are listed below.
Pkts/s
Throughput
Average Bit
Speed
% Non-Unicast
Average Signal
button to save the trap settings.
(each associated Access Port), or
The maximum threshold for the number of packets per second before a trap is sent.
The maximum threshold for the total throughput in Mbps (Megabits per second) for each
of the devices before a trap is sent.
The minimum threshold for the average bit speed in Mbps (Megabits per second) for each
of the devices before a trap is sent.
The maximum threshold for the total percentage of packets that are non-unicast for each
of the devices before a trap is sent. Non-unicast packets include broadcast and multi-cast
traffic.
The minimum threshold for the average signal strength in dBm for each of the devices
before a trap is sent.
[System Configuration] -->
Switch (the switch as a whole),
Mu (each mobile unit connected to the switch).
Switch Administration
SNMP Access --> SNMP RF
Wlan (for each WLAN
7-23