Motorola WS2000 System Reference Manual page 173

1. To set the SNMP traps, select
left menu.
2. Check the type of traps to enable the generation of notification events.
Trap Trap Name
Category
System System Cold Start
Traps
Configuration
Changes
User Login Failure
Admin Password
Change
Low Compact Flash
Memory
Network Physical port status
Traps change
Interface Status
Change
DynDNS Update
Denial of service
(DOS) attempts
[System Configuration] -->
Generates a Trap whenever...
The switch's router reinitializes while transmitting, possibly altering the
agent's configuration or protocol entity implementation.
SNMP access or management functions are reconfigured.
A user fails to successfully login from the CLI or Applet.
A change is made to the Admin user password.
The memory in the Compact Flash card in the system falls below the
amount specified.
The status changes for one of the ports on the front of the WS2000, such
as if a device is plugged into or unplugged from the switch, or if the link is
lost between the switch and the connected device.
An interface on the switches status changes from its configured state.
If Dynamic DNS services are configured on the WAN a new trap is set
when there is a Dynamic DNS update.
A Denial of Service attack is detected by the switch's firewall. A new trap
will be sent at the interval specified until the attack has stopped.
Switch Administration
SNMP Access --> SNMP Traps
7-21
from the