Defining And Maintaining Approved Ap List Rules - Motorola WS2000 System Reference Manual

5-34 WS2000 Wireless Switch System Reference Guide
NOTE: Note that only some access ports have the capability of being a Detector AP, including Motorola
AP 100, AP 200, and AP 300 Access Ports.
5. In the Scan Interval
of the selected detection methods. By default, these scans are set at one hour intervals.
NOTE: Scan interval for Full Detector AP is defined in seconds. For other scans, the interval is defined in
minutes.

5.9.2 Defining and Maintaining Approved AP List Rules

The lower half of the Rogue AP Detection screen specifies rules that determine whether a detected AP can
be approved or not. Each entry in the table works as an AP evaluation rule. You can specify a particular MAC
address or a particular ESSID, or you can indicate that any MAC address or ESSID will work. However, if you
select Any MAC
1. Check the Approve Any AP Having a Symbol Defined MAC Address
Motorola AP (that is, one that has a known Motorola MAC address) is an approved AP.
2. Click the Add
Any MAC
MAC
Address
Any ESSID
ESSID
3. To delete a particular rule from the table, select the rule and then click the
4. Click the Delete All
field, enter a time interval (in minutes) between detection RF scans. Do this for each
and Any ESSID on the same line, all APs will be approved. Up to 20 rules can be defined.
button to add a line in the rule table and then fill out the following table cells:
Check this box to indicate that an AP with any MAC address matches the rule.
Enter an approved MAC address to be used during the detection process. This field is only used
when Any MAC (on the same line) is not checked.
Check this box to indicate that an AP with any ESSID matches the rule.
Enter an approved ESSID to be used during the detection process. This field is only used when
Any ESSID (on the same line) is not checked.
button to clear the entire rule list.
box to indicate that any
Del button.