Creating User Defined Routes; Setting The Rip Configuration - Motorola WS2000 System Reference Manual

4-16 WS2000 Wireless Switch System Reference Guide
Subnet 1
Subnet 2
Subnet 3
Subnet 4
Subnet 5
Subnet 6
default

4.5.2 Creating User Defined Routes

The User Defined Routes
(dedicated) routes, and to enable or disable routes that are generated using the Routing Information Protocol
(RIP). If RIP is enabled, this table can also include routes that RIP generates.
This table also includes internal static routes that the administrator adds. Internal static routes are dedicated
routes for data that travels from the WAN, through the switch, and to a specified subnet. Such routes are
supplemental to the default routes already set up for each of the subnets.
1. Click the Add
2. Specify the destination IP address, subnet mask, and gateway information for the internal static route.
3. Select an enabled subnet from the
Information in the
determine the best hop routes.
4. Click the Apply

4.5.3 Setting the RIP Configuration

Routing Information Protocol (RIP) is an interior gateway protocol that specifies how routers exchange
routing-table information. The Routing screen also allows the administrator to select the type of RIP and the
type of RIP authentication used by the switch. To set or view the RIP configuration, click the
Configuration
If Subnet 1 is enabled, sets it as the Default Gateway Interface for all unspecified
routes.
If Subnet 2 is enabled, sets it as the Default Gateway Interface for all unspecified
routes.
If Subnet 3 is enabled, sets it as the Default Gateway Interface for all unspecified
routes.
If Subnet 4 is enabled, sets it as the Default Gateway Interface for all unspecified
routes.
If Subnet 5 is enabled, sets it as the Default Gateway Interface for all unspecified
routes.
If Subnet 6 is enabled, sets it as the Default Gateway Interface for all unspecified
routes.
Sets the gateway to default
area of the screen allows the administrator to view, add or delete internal static
button to create a new table entry.
Interface
Metric column is automatically generated, and is used by router protocols to
button to save changes.
button. The following subscreen appears.
for all unspecified routes.
column's drop-down menu to complete the table entry.
RIP