Paging - Toshiba VIPedge User Manual

Destination Restriction/
Traveling Class Override
Class of Service Override
Privacy Override

Paging

VIPedge UG 12/12
Enables a station user to override the Destination Restriction or Traveling
Class of a particular telephone by entering a pre-determined account code.
To use Destination Restriction or Traveling Class Override
1. Press #471. A Confirmation tone plays and the LCD shows "Enter OVR
Code."
2. Enter the trunk access code or LCR access code.
3. Dial the external telephone number.
By dialing a Class of Service (COS) Override code, a user can change a
station's set of privileges to one associated with the override code. When the
call is terminated and another is attempted from the same station, the original
COS is applied. This allows selected users to override restrictions that are
placed on any telephone in the system.
To perform Class of Service Override
1. Access a Primary or Phantom DN. You hear a dial tone and the LED
flashes at the in-use rate.
2. Press #471. Dial tone stops. Your LCD prompts you to enter a code.
3. Enter the COS Override Code (four digits). You hear a dial tone.
4. Dial a telephone number.
For security reasons, the override codes are only available on a
Note:
selected basis. See your System Administrator.
This feature enables you to enter an established call on a line you share with
another telephone. Up to two station users can enter an existing Central
Office (CO) line-to-station call (i.e., up to three stations can be connected to a
CO line). You can also use this feature if the station that is already connected
to the CO line is in the Privacy Release mode.
Station users with Privacy Release can allow stations with the shared
button appearance to enter their conversations, even if the station entering
the conversation is not programmed for Privacy Override.
Station users can make page announcements to telephones. Check with your
System Administrator to find out the zone numbers for various paging groups.
Verify with your System Administrator if there are sufficient vacant media
resources for successful paging.
To make a Page announcement to telephones:
1. Lift the handset, press your extension button and enter a paging access
code.
2. Make your announcement, then hang up.
To make a Group Page
Press Group Page and enter the Group number (01~24)
•
— or —
Press extension + #31 and enter the zone number.
•
TOSHIBA
VIPedge
Feature Operations
43