Table of Contents
Advertisement
4. 802.1x Mode
RADIUS server is needed while 802.1x mode is enabled.
IP Address
Input RADIUS server IP.
RADIUS Port
Input RADIUS service port.
Shared Secret
Input initial shared key.
Session Timeout
Input a maximum idle time. If the link idles over time, the connection will be terminated.
8.2.3 WPS Config
Users can enable WPS function when using WPA Personal, WPA2 Personal and WPA/WPA2 Personal Mixed Mode.
When WPS is enabled, the mode will continue for 2 minutes. If there is no connection established in two minutes,
this connection wil be stopped.
1. Use personal PIN code to configure WPS
(1) Enable WPS.
(2) Input wireless client device PIN code. AP PIN code should be also written in client device.
(3) Click "Connect" to establish connection.
(4) Check if WPS connection is established successfully on client device.
2. Use PBC to configure WPS
(1) Enable WPS.
(2) Check "PBC" and click "connect"to establish connection. Uses can also push the WPS button on front panel
for 5 seconds.
(3) Check if WPS connection is established successfully on client device.
81
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
t
e
r
t
e
r
Advertisement
Table of Contents
