Table of Contents
Advertisement
10.1.1.1. Gateway to Gateway Setting
The following instructions will guide users to set a VPN tunnel between two devices.
Tunnel No.：
Tunnel Name：
Interface：
Enabled：
Local Group Setup：
This Local Security Gateway Type must be identical with that of the remote type (Remote Security
Gateway Type).
Set the embedded VPN feature, please select the Tunnel number.
Displays the current VPN tunnel connection name, such as XXX Office. Users
are well-advised to give them different names to avoid confusion.
Note: If this tunnel is to be connected to the other VPN device, some device
requires that the tunnel name is identical to the name of the host end to facilitate
verification. This tunnel can thus be successfully enabled.
From the pull-down menu, users can select the Interface for this VPN tunnel.
Click to activate the VPN tunnel. This option is set to activate by default.
Afterwards, users may select to activate this tunnel feature.
136
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
t
e
r
t
e
r
Advertisement
Table of Contents
