Table of Contents
Advertisement
Step 3: QoS Configuration
Interface
Source IP/Group
Upstream/Downstream
Bandwidth sharing
Select on which WAN the QoS rule should be executed. It can be a single
selection or multiple selections.
This is to select which user is to be controlled. If only a single IP is to be
restricted, input this IP address, such as "192.168.1.100 to 100". The rule will
control only the IP 192.168.1.100. If an IP range is to be controlled, input the
range, such as "192.168.1.100 ~ 149". The rule will control IP addresses from
192.168.1.100 to 149.
Upstream：Means the upload bandwidth for Intranet IP.
Downstream：Means the download bandwidth for Intranet IP.
Sharing total bandwidth with all IP addresses: If this option is selected, all IP
addresses or Service Ports will share the bandwidth range (from minimum to
maximum bandwidth).
Assign bandwidth for each IP address: If this option is selected, every IP or
Service Port in this range can have this bandwidth (minimum to maximum). For
example, If the rule is set for the IP of each PC, the IP of each PC will have the
same bandwidth.
※Attention: If "Share-Bandwidth" is selected, be aware of the actual usage
conditions and avoid an improper configuration that might cause a malfunction of
the network when the bandwidth is too small. For example, if users do not want
an FTP to occupy too much bandwidth, users can select the "Share-Bandwidth
Mode", so that no matter how much users use FTPs to download information, the
total occupied bandwidth is fixed.
126
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
t
e
r
t
e
r
Advertisement
Table of Contents
