Table of Contents
Advertisement
Source IP:
Dest. IP:
Interface:
Enable:
Add To List:
Delete selected
item:
Moving Up &
Down:
Note！
The rules configured in Protocol Binding will be executed by the device according to their priorities
too. The higher up on the list, the higher the priority of execution.
selected from the pull-down option list. The default Service is All 0~65535.
Option List for Service Management: Click the button to enter the Service
Port configuration page to add or remove default Service Ports on the
option list.
Users can assign packets of specific Intranet virtual IP to go through a
specific WAN port for external connection. In the boxes here, input the
Intranet virtual IP address range; for example, if 192.168.1.100~150 is
input, the binding range will be 100~150. If only specific Service Ports need
to be designated, while specific IP designation is not necessary, input "0" in
the IP boxes.
In the boxes, input an external static IP address. For example, if
connections to destination IP address 210.11.1.1 are to be restricted to
WAN1, the external static IP address 210.1.1.1 ~ 210.1.1.1 should be input.
If a range of destinations is to be assigned, input the range such as
210.11.1.1 ~ 210.11.255.254. This means the Class B Network Segment of
210.11.x.x will be restricted to a specific WAN. If only specific Service Ports
need to be designated, while a specific IP destination assignment is not
required, input "0" into the IP boxes.
Select the WAN for which users want to set up the binding rule.
To activate the rule.
To add this rule to the list.
To remove the rules selected from the Service List.
The priority for rule execution depends on the rule order in the list. A rule
located at the top will be executed prior to those located below it. Users can
arrange the order according to their priorities.
47
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
t
e
r
t
e
r
Advertisement
Table of Contents
