Table of Contents
Advertisement
WANs (WAN2) are broken and connection error remove (Remove the Connection) has been selected
for the connection detection system, traffic will be shifted to the first WAN (WAN1). In addition, if the first
WAN (WAN1) is broken, the traffic will be shifted to other WANs in turn. For example, the traffic will be
shifted to WAN2.
6.2.3 Protocol Binding
Interface Configuration
Router allows maximum two WAN interface, the bandwidth and real connection of every WAN will impact
the load balance mechanism; therefore you need to set the Bandwidth and the Network service detection by
each WAN Port correctly.
In "WAN Setting", click "Edit" to enter the WAN port configuration.
Bandwidth Configuration
When Auto Load Balance mode is selected, the device will select sessions or IP and the WAN bandwidth
will automatically allocate connections to achieve load balancing for external connections. The network
bandwidth is set by what users input for it. For example, if the upload bandwidth of both WANs is 512Kbit/sec,
the automatic load ratio will be 1:1; if one of the upload bandwidths is 1024Kbit/sec, while the other is
512Kbit/sec, the automatic load ratio will be 2:1. Therefore, to ensure that the device can balance the actual
network load, please input real upload and download bandwidths. The section refers to QoS configuration.
Therefore, it should be set in QoS page. Please refer to 8.1 QoS bandwidth configuration.
Protocol Binding
Users can define specific IP addresses or specific application service ports to go through a user-assigned
45
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
t
e
r
t
e
r
Advertisement
Table of Contents
