Table of Contents
Advertisement
As in the figure below, select "All Traffic" from the pull-down option list "Service", and then in the
boxes of "Source IP" input the source IP address "192.168.1.100" to "100". Retain the original numbers
"0.0.0.0" in the boxes of "Destination IP" (which means to include all Internet IP addresses). Select
WAN2 from the pull-down option list "Interface", and then click "Enable". Finally, click "Add New" and
the rule will be added to the mode.
Example 2：How do I set up Auto Load Balance Mode to keep Intranet IP 192.168.1.150 ~ 200 from
going through WAN2 when the destination port is Port 80?
As in the figure below, select "HTTP [TCP/80~80]" from the pull-down option list "Service", and
then in the boxes for "Source IP" input "192.168.1.150" to "200". Retain the original numbers "0.0.0.0"
in the boxes of "Destination IP" (which means to include all Internet IP addresses). Select WAN2 from
the pull-down option list "Interface", and then click "Enable". Finally, click "Add New" and the rule will be
added to the mode.
50
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
V
P
N
Q
o
S
W
i
r
e
l
e
s
s
R
o
u
t
e
r
t
e
r
Advertisement
Table of Contents
